PIM-STD/4/INVALID_REG
Message
PIM-STD/4/INVALID_REG:PIM receives an invalid register message. (GroupMappingOrigin=[GroupMappingOrigin], GroupMappingAddressType=[GroupMappingAddressType], GrpAddr=[GrpAddr], GrpPfxLen=[GrpPfxLen], GroupMappingRPAddressType=[GroupMappingRPAddressType], RPAddr=[RPAddr], GroupMappingPimMode=[GroupMappingPimMode], InvRegAddressType=[InvRegAddressType], InvRegOriginAddr=[InvRegOriginAddr], InvRegGrpAddr=[InvRegGrpAddr], InvRegRpAddr=[InvRegRpAddr])
Parameters
Parameter Name | Parameter Meaning |
---|---|
GroupMappingOrigin | RP type |
GroupMappingAddressType | Group address type |
GrpAddr | Group address of the Registered messages |
GrpPfxLen | Mask length of the multicast group address |
GroupMappingRPAddressType | RP address type |
RPAddr | Address of the RP serving the multicast group |
GroupMappingPimMode | Current PIM mode |
InvRegAddressType | Address type of the invalid Register messages |
InvRegOriginAddr | Source address of the invalid Register messages |
InvRegGrpAddr | Group address of the invalid Register messages |
InvRegRpAddr | Destination address of the invalid Register messages |
Procedure
- Check whether the SSM group address ranges configured on
the source's DR and the RP are consistent.
- If the SSM group address ranges are consistent, check whether the RP configurations on the source's DR and the local device generating the log are consistent. If not, correct the RP configurations.
- If the SSM group address ranges are inconsistent, run the ssm-policy command to reconfigure the SSM group address ranges.