OSPFV3/2/ospfv3ImptLsaMaxExceed_active
Message
OSPFV3/2/ospfv3ImptLsaMaxExceed_active:The number of AS-external LSAs generated when an OSPFv3 process imports external routes exceeds the configured maximum number.(hwOspfv3ProcessId=[hwOspfv3ProcessId], hwOspfv3MaxLimit=[hwOspfv3MaxLimit])
Description
The number of ASE LSAs generated when an OSPFv3 process imported external routes reached or exceeded the maximum number allowed.
Parameters
Parameter Name | Parameter Meaning |
---|---|
hwOspfv3ProcessId |
OSPFv3 process ID |
hwOspfv3MaxLimit |
Limit on the maximum number of ASE LSAs |
Possible Causes
The number of ASE LSAs generated when an OSPFv3 process imported external routes reached or exceeded the maximum number allowed.
Procedure
- Run the display ospfv3 command to check whether the number
of ASE LSAs generated when an OSPFv3 process imported external routes
reaches or exceeds the maximum number allowed.
If the number reaches or exceeds the maximum number allowed, this trap message is informational only and no action is required.
If the number has not reached or exceeded the maximum number allowed, go to Step 2.
NOTE:
Check the overload status based on the value of the Current status field in the display ospfv3 command output.- Normal: The number of LSAs generated when an OSPFv3 process imports external routes is less than or equal to the lower alarm threshold (in percentage) multiplied by the maximum number allowed.
- Approach limit: The number of LSAs generated when an OSPFv3 process imports external routes is approaching (reaching or exceeding 90% of) the upper alarm threshold.
- Exceed limit: The number of LSAs generated when an OSPFv3 process imports external routes has reached or exceeded the maximum number allowed.
- Perform the following operations as required:
- If a change in the limit on the number of ASE LSAs is allowed, run the import-route limit limit-number [ threshold-alarm { upper-limit upper-limit-value | lower-limit lower-limit-value } * ] command to change the limit.
- If a change in the limit on the number of ASE LSAs is not allowed, go to Step 3.
- contact technical support personnel
- End.