No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Association Between VRRP and BFD/NQA/Routing to Monitor the Uplink

Association Between VRRP and BFD/NQA/Routing to Monitor the Uplink

VRRP can only detect faults in VRRP groups. Association between a VRRP group and the interface status allows the device to detect faults on the uplink interface or direct uplink of the master. When an indirect uplink of the master fails, VRRP cannot detect the fault, causing loss of user traffic. To resolve this issue, you can configure association between VRRP and BFD/NQA/routing. Association between VRRP and BFD/NQA/routing allows the device to detect faults on the uplink of the master. When the uplink of the master fails, BFD/NQA/routing rapidly detects the fault and instructs the master to adjust its priority. This triggers an active/standby switchover and ensures proper traffic forwarding.

Figure 3-9 Association between VRRP and BFD/NQA/routing

In Figure 3-9, a VRRP group is configured between SwitchA and SwitchB, which are the master and backup, respectively. Both switches work in preemption mode. BFD/NQA/routing is configured to detect faults on the link from SwitchA to SwitchE, and association between VRRP and BFD/NQA/routing is configured on SwitchA. When BFD/NQA/routing detects the fault on the link from SwitchA to SwitchE, BFD/NQA/routing instructs the master to adjust its priority. SwitchB becomes the master through negotiation, ensuring that user traffic is forwarded correctly.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100040245

Views: 38692

Downloads: 118

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next