No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Interval for Sending Advertisement Packets

(Optional) Setting the Interval for Sending Advertisement Packets

Context

An interface in Advertisement state sends Advertisement packets. DLDP creates a neighbor entry, starts the entry timer, and transits to the Probe state if the neighbor entry does not exist on the peer interface. DLDP updates the entry timer if the neighbor entry exists.

The interval for sending Advertisement packets must be smaller than one third of the STP convergence time. If the interval is too long, STP loops occur when a unidirectional link is still enabled on a DLDP interface. If the interval is too short, the traffic volume on the network increases.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dldp interval interval

    The interval for sending Advertisement packets is set.

    By default, the interval for sending the Advertisement packets is 5 seconds.

    NOTE:

    The same interval for sending Advertisement packets must be set on the local and remote devices that are connected through optical fibers or copper twisted pairs; otherwise, DLDP cannot work properly.

  3. Run commit

    The configuration is committed.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100040245

Views: 35700

Downloads: 118

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next