No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Reliability

CloudEngine 8800, 7800, 6800, and 5800 V200R005C00

This document describes the configurations of Reliability, including BFD Configuration, VRRP Configuration, DLDP Configuration, Smart Link and Monitor Link Configuration, EFM Configuration, and CFM Configuration.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BFD for BGP

BFD for BGP

Border Gateway Protocol (BGP) enables the switch to periodically send Keepalive packets to its peers for fault detection. Detecting a fault using this method takes more than 1 second. When traffic is transmitted at gigabit rates, such slow fault detection causes significant packet loss. Association between BFD and BGP enables BFD to quickly detect faults on links between BGP peers and report the faults to BGP, implementing fast BGP route convergence. Table 2-3 lists BGP convergence time.

Table 2-3 BGP convergence time

BFD Session

Link Fault Detection Mechanism

Convergence Time

Not bound

Keepalive packet mechanism

Measured in seconds

Bound

BFD session in Down state

Measured in milliseconds

Application

Figure 2-8 BFD for BGP

In Figure 2-8, SwitchA belongs to AS 100, and SwitchB belongs to AS 200. SwitchA and SwitchB are directly connected and establish an External Border Gateway Protocol (EBGP) connection. BFD monitors the status of the EBGP connection between SwitchA and SwitchB. When the link between SwitchA and SwitchB becomes faulty, BFD can quickly detect the fault and notify BGP.

Translation
Download
Updated: 2019-04-20

Document ID: EDOC1100040245

Views: 35737

Downloads: 118

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next