No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
IPSEC_1. hwIPSecTunnelStart

IPSEC_1. hwIPSecTunnelStart


IPSEC/4/IPSECTUNNELSTART: OID [oid] The IPSec tunnel is established. (Ifindex=[Ifindex], SeqNum=[SeqNum],TunnelIndex=[TunnelIndex], RuleNum=[RuleNum], DstIP=[DstIP], InsideIP=[InsideIP], RemotePort=[RemotePort], CpuID=[CpuID], SrcIP=[SrcIP], FlowInfo=[FlowInfo], LifeSize=[LifeSize], LifeTime=[LifeTime], VsysName=[vsys-name], InterfaceName=[InterfaceName], SlotID=[SlotID], Role=[Role])

An IPSec tunnel is established.


Alarm ID Alarm Severity Alarm Type Warning Communications alarm


Name Meaning
oid Indicates the MIB object ID of the alarm.
Ifindex Indicates the interface index.
SeqNum Indicates the policy number.
TunnelIndex Indicates the tunnel index.
RuleNum Indicates the rule number.
DstIP Indicates the IP address of the peer end of the IPSec tunnel.
InsideIP Indicates the intranet IP address of the peer end of the tunnel.
RemotePort Indicates the port number of the peer end of the IPSec tunnel.
CpuID Indicates the CPU number.
SrcIP Indicates the IP address of the local end of the IPSec tunnel.
FlowInfo Indicates the data flow information of the IPSec tunnel, including the source address, destination address, ACL port number, ACL protocol number, and DSCP.
LifeSize Indicates the life cycle of the tunnel, in kbytes.
LifeTime Indicates the life cycle of the tunnel, in seconds.


Indicates the name of the virtual system to which the IPSec policy belongs.


The device does not support this parameter.

InterfaceName Indicates the interface name.

Indicates the Slot number.


The device does not support this parameter.


Device role during SA negotiation:

  • Initiator: The device functions as the SA negotiation initiator.
  • Responder: The device functions as the SA negotiation responder.

Impact on the System


Possible Causes

When an IPSec tunnel is established successfully, the alarm is generated.


  • This trap message is informational only, and no action is required.
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 106612

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next