No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
POE_1.3.6.1.4.1.2011.5.25.195.40.16 hwPoePdPriorityDifferent

POE_1.3.6.1.4.1.2011.5.25.195.40.16 hwPoePdPriorityDifferent

Description

POE/4/PDPRIDIFF: OID [oid] priority corrupt.(IfIndex=[INTEGER], Interface="[OCTET]", PortPriority=[INTEGER], PDPriority=[INTEGER])

The PD priority configured on the interface differs from the one obtained through LLDP negotiation.

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.4.1.2011.5.25.195.40.16

Warning

qualityOfServiceAlarm(3)

Parameters

Name Meaning

OID

Indicates the MIB object ID of the alarm.

IfIndex

Indicates the interface index.

Interface

Indicates the interface name.

PortPriority

Indicates the PD priority configured on the interface.
  • 1: critical
  • 2: high
  • 3: low (default)

PDPriority

Indicates the PD priority obtained through LLDP negotiation.
  • 1: critical
  • 2: high
  • 3: low (default)

Impact on the System

Services are not affected.

Possible Causes

Cause 1:

The PD priority configured on the interface is high, whereas that obtained through LLDP negotiation is low.

Cause 2:

The PD priority configured on the interface is low, whereas that obtained through LLDP negotiation is high.

Procedure

  • Run the poe priority command to change the PD priority configured on the interface to the same as the one obtained through LLDP negotiation.

Related Information

None.

Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 69845

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next