No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
VRRP_1. vrrpTrapAuthFailure

VRRP_1. vrrpTrapAuthFailure


VRRP/1/VRRPAUTHFAILED:OID [oid] VRRP failed to authentication. (IPAddress=[IPAddress], AuthErrorType=[AuthErrorType])

The authentication mode or authentication key of the received VRRP multicast packets was inconsistent with that of the local router.


Alarm ID Alarm Severity Alarm Type Critical communicationsAlarm(2)


Name Meaning


Indicates the MIB object ID of the alarm.


IP address of the interface where a VRRP backup group is configured


Authentication failure types in the VRRP group.
  • 1: invalid authentication mode
  • 2: inconsistent authentication types on two devices in a VRRP backup group
  • 3: authentication failure

Impact on the System

The failure of the negotiation between the VRRP backup group may cause the services to be interrupted.

Possible Causes

Cause 1:

The authentication mode or authentication key of the received VRRP packets was inconsistent with that of the local router.

Cause 2:

Authentication configured on one end is deleted.


  1. Run the display vrrp command to view the Auth Type field and Auth Key field. Check whether the authentication type and key are configured to be the same on both devices in a VRRP backup group.

    • If not, configure the authentication type and key to be consistent. Go to Step 3.
    • If so, go to Step 2.

  2. Collect alarm information and configuration information, and then contact technical support personnel.
  3. End.
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 106725

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next