No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.80 hwMplsTunnelHotstandbyResume

LSPM_1.3.6.1.4.1.2011.5.25.121.2.1.80 hwMplsTunnelHotstandbyResume

Description

LSPM/2/MPLSTUNNELHOTSTANDBYRESUME:OID [oid] Traffic switched back from the hot-standby LSP to the primary LSP.(SessionTunnelId=[integer], LocalLspId=[integer], IngressLsrId=[integer], EgressLsrId=[integer], TunnelName=[OCTET])

The trap message was output when the primary LSP went Up and traffic was switched back from the hot-standby LSP to the primary LSP.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.121.2.1.80

Major

communicationsAlarm(2)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

SessionTunnelId

Indicates the ID of the tunnel.

LocalLspId

Indicates the local LSP ID of a tunnel.

IngressLsrId

Indicates the LSR ID of the ingress on the tunnel.

EgressLsrId

Indicates the LSR ID of the egress on the tunnel.

TunnelName

Indicates the tunnel name.

Impact on the System

Services will not be affected.

Possible Causes

When the tunnel was in the HSB inuse state, the status of the primary LSP changed from Down to Up.

Procedure

  • This trap message is informational only, and no action is required.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 72007

Downloads: 47

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next