No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RSVP_1.3.6.1.4.1.2011.5.25.148.1.12.2.7 hwRsvpTeIfNbrTotalCountExceed

RSVP_1.3.6.1.4.1.2011.5.25.148.1.12.2.7 hwRsvpTeIfNbrTotalCountExceed

Description

RSVP/2/RSVPIFNBRTOTALCOUNTEXCEED: OID [oid] The number of RSVP neighbors reached the maximum number. (hwRsvpTeIfName=[octet], hwRsvpTeNbrTotalCount=[integer])

The number of configured RSVP neighbors reached the maximum number of supported RSVP neighbors.

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.4.1.2011.5.25.148.1.12.2.7

Major

qualityOfServiceAlarm(3)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

hwRsvpTeIfName

Name of an RSVP interface

hwRsvpTeNbrTotalCount

Maximum number of RSVP neighbors that a device supports

Impact on the System

If new RSVP neighbors are created after the number of existing RSVP neighbors on a specified interface has reached the upper threshold, services may be affected.

Possible Causes

The number of configured RSVP neighbors on a device reached the maximum number of supported RSVP neighbors.

Procedure

  1. Check the hwRsvpTeIfName field and obtain information about the interface on which the alarm is generated.
  2. Run the undo mpls rsvp-te command in the interface view to delete unwanted RSVP interface configurations or delete unwanted RSVP interface configurations on the peer interface to reduce the number of RSVP neighbors. Then check whether the alarm is cleared.
    • If the alarm is cleared, go to Step 4.
    • If the alarm persists, go to Step 3.
  3. Collect alarm information and configuration information, and then contact technical support personnel.
  4. End.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 70306

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next