No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
RM_1.3.6.1.4.1.2011.5.25.145.19.2.2 hwPublicIpv6PrefixExceedClear

RM_1.3.6.1.4.1.2011.5.25.145.19.2.2 hwPublicIpv6PrefixExceedClear

Description

RM/2/PUBLIC_IPV6_PREFIX_EXCEED_RESM:OID [oid] The number of public IPv6 prefixes falls below the maximum value. (PrefixCount=[Integer], MaxValue=[Integer])

The number of IPv6 public route prefixes fell below that supported by the system.

Attribute

Alarm ID Alarm Severity Alarm Type

1.3.6.1.4.1.2011.5.25.145.19.2.2

Major

qualityOfServiceAlarm(3)

Parameters

Name Meaning

oid

Indicates the MIB object ID of the alarm.

PrefixCount

Indicates the number of IPv6 public route prefixes in the routing table.

MaxValue

Indicates the maximum number of IPv6 public route prefixes supported by the device.

Impact on the System

Services will not be affected.

Possible Causes

Cause 1:

The network administrator deleted some routes from the routing table or the number of routes learned by dynamic protocols decreased due to network topology changes.

Cause 2:

The maximum number of IPv6 public route prefixes supported by the system was increased or the limit on the number of IPv6 public route prefixes was deleted.

Procedure

  1. This alarm message is informational only, and no action is required.
Translation
Download
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 69642

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next