No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
WLAN_1. hwApConflictApNameTrap

WLAN_1. hwApConflictApNameTrap


WLAN/4/AP_REPORT_NAME_CONFLICT_NOTIFY:OID [oid] Report ap name conflict. (APMAC=[OPAQUE], APReportName=[OCTET], APOccurTime=[OCTET], APID=[INTEGER])

The name of a new online AP reported to the AC conflicts with that of an existing online AP.


Alarm ID Alarm Severity Alarm Type Warning equipmentAlarm (5)


Name Meaning
OID Indicates the ID of the MIB object.
ApMac Indicates the MAC address of an AP.
ApName Indicates the AP name.
APOccurTime Indicates the time when the alarm is generated.
APID Indicates the AP ID.

Impact on the System

Two different APs use the same name, causing a failure in AP information query based on the AP name.

Possible Causes

The name configured on the AP conflicts with that of an online AP on the AC.


  1. Log in to the AP and run the ap-rename { ap-name name | ap-mac ap-mac-address | ap-id ap-id } new-name ap-new-name command to modify the name of the AP to prevent name conflict.
  2. Restart the AP. Then, check whether the alarm persists.

    • If so, go to Step 3.
    • If not, go to Step 4.

  3. Collect alarm messages, log messages, and configurations, and then contact the technical support personnel.
  4. End.

Related Information


Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 101513

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next