No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
BULKSTAT_1. hwBulkStatURLConnectionFail

BULKSTAT_1. hwBulkStatURLConnectionFail


BULKSTAT/2/CONNECTION_FAILED:OID [oid] Failed to upload the URL. (FileIndex=[integer], FileName=[octet],PrimaryUrl=[octet], SecondaryUrl=[octet])

Uploading files through FTP failed after using both the primary and secondary URLs. The trap cannot be resent. No trap is sent when the upload fails again.


Alarm ID Alarm Severity Alarm Type Major processingErrorAlarm(4)


Name Meaning


Indicates the MIB object ID of the alarm.


Indicates the index of a file.


Indicates the name of a file.


Indicates the primary URL.


Indicates the secondary URL.

Impact on the System

The data collected in this uploading interval needs to be retransmitted, and the system will not be affected.

Possible Causes


The configured primary transfer URL and secondary transfer URL were incorrect.


The configuration of the FTP/TFTP server was incorrect.


The link connecting the local device to the file server was faulty.


  1. Check whether the user name of the FTP/TFTP and the password of FTP is correctly configured. In addition, check whether the server can be started normally.

    • If so, go to Step 2.

    • If not, go to Step 3.

  2. Run the ping command to check whether the link is in the normal state.

    • If so, go to Step 4.

    • If not, go to Step 3.

  3. Re-configure the upload link or the server. Observe a whole collection interval to find whether the trap indicating the link recovery is received.

    • If so, go to Step 5.

    • If not, go to Step 4.

  4. Collect alarm information and configuration information, and then contact technical support personnel.
  5. End.
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 101121

Downloads: 61

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next