No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
WLAN_1. hwWlanWidsFloodAttackDetectedTrap

WLAN_1. hwWlanWidsFloodAttackDetectedTrap


WLAN/4/WIDS_DETECT_ATTACK_NOTIFY:OID [oid] Detected attack. (Monitor AP mac=[OPAQUE], Device Mac=[OPAQUE], Device channel=[INTEGER], Attack type=[INTEGER], Attack type string=[OCTET])

A flood attack was detected.


Alarm ID Alarm Severity Alarm Type Warning environmentalAlarm(6)


Name Meaning
oid Indicates the OID of the alarm.
Monitor AP mac Indicates the MAC address of a monitoring AP.
Device Mac Indicates the MAC address of the attacking device.
Device channel Indicates the channel of the attacking device.
Attack type
Indicates the ID of attack type.
  • 0: Probe Request Flood Attack
  • 1: Authentication Request Flood Attack
  • 2: Deauthentication Frame Flood Attack
  • 3: Association Request Flood Attack
  • 4: Disassociation Request Flood Attack
  • 5: Reassociation Request Flood Attack
  • 6: Action Frame Flood Attack
  • 9: EAPOL Start Frame Flood Attack
  • 10: EAPOL Logoff Frame Flood Attack
Attack type string Indicates the character string describing the attacking device type.

Impact on the System

The device is busy processing flood attack packets, which occupies too many CPU resources.

Possible Causes

A flood attack was detected.


  1. Run the display wlan ids attack-detected and display wlan ids attack-detected statistics commands to check information about attacking devices and attack statistics and determine whether a flood attack occurs.

    • If not, go to Step 2 and modify the attack alarm threshold to prevent incorrect alarm reports.
    • If so, go to Step 3 and configure the dynamic blacklist function.

  2. Configure the attack alarm threshold.

    Enter the WIDS profile view and run the flood-detect interval and flood-detect threshold commands to configure the flood attack detection period and the maximum number of packets of the same type that an AP can receive within the period.

  3. Add the attacking device to the dynamic blacklist so that packets from the device will be discarded.
    1. Enter the specified WIDS profile view and run the dynamic-blacklist enable command to enable the dynamic blacklist function.
    2. Enter the specified AP system profile view and run the dynamic-blacklist aging-time command to configure an aging time for the dynamic blacklist entries.
  4. Then, check whether the alarm persists.

    • If so, go to Step 5.
    • If not, go to Step 6.

  5. Collect alarm messages, log messages, and configurations, and then contact the technical support personnel.
  6. End.

Related Information


Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 107464

Downloads: 68

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next