No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Alarm Handling

AR100, AR120, AR160, AR1200, AR2200, AR3200, and AR3600 V300R003

This document provides the trap description, attributes, parameters, impact on the system, possible causes, procedures, and references. This document provides a complete set of traps, through which intended readers are kept of the running status of the device so as to locate faults.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
PKI_1. hwPKIGetCertFailLdap

PKI_1. hwPKIGetCertFailLdap


PKI/4/PKIGETCERTFAILLDAP: OID [oid] get certificate unsuccessfully with LDAP. (hwLdapIP=[ldapip], hwLdapPort=[ldapport], hwCertAttribute=[certattribute], hwCertDN=[certdn], hwLdapVersion=[ldapversion], hwCertSaveName=[certsavename])

The system failed to obtain the certificate through LDAP.


Alarm ID Alarm Severity Alarm Type Warning communicationsAlarm


Name Meaning
oid Indicates the MIB object ID of the alarm.
ldapip Indicates the IP address of the LDAP server.
ldapport Indicates the port number of the LDAP server.
certattribute Indicates the attribute of the certificate.
certdn Indicates the DN of the certificate.
ldapversion Indicates the version of the LDAP server.
certsavename Indicates the name of the saved certificate file.

Impact on the System

The service becomes invalid after the certificate expires.

Possible Causes

  • There is no reachable route between the device and LDAP server.
  • The PKI configurations of the device and LDAP server are incorrect.
  • The LDAP server is faulty.


  1. Run the ping command to check whether there is a reachable route between the device and LDAP server.

    If not, check the route and link to ensure that there is a reachable route between the device and LDAP server.

  2. Check whether the PKI configurations of the device and LDAP server are correct. The PKI configurations include the LDAP server IP address, port, and version.

    If not, ensure that the PKI configurations are correct.

  3. Check whether the LDAP server is working properly.

    If not, ensure that the LDAP server is working properly.

  4. Collect alarm and configuration information, and contact technical support personnel.
Updated: 2019-03-06

Document ID: EDOC1100041475

Views: 107522

Downloads: 68

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next