AR617VW-LTE4EA (50010564-006)
Overview
| Item | Details |
|---|---|
| Description | AR617VW-LTE4EA, 1*GE COMBO WAN, 4*GE LAN, 1*VDSL2, 2*FXS, 1*USB 2.0, 1*LTE, Wi-Fi 2.4G+5G |
| Part Number | 50010564-006 |
| Model | AR617VW-LTE4EA |
| First supported version | V300R019C10SPC600+SPH380 |
| Remarks | support only V300R019C10SPC600+SPH380 and later versions |
Appearance
Components
1. Power jack |
2. RESET button NOTE:
This button is used to reset the router.
|
3. USB interface 2.0 (host) |
4. Console interface |
5. LAN interfaces: four GE electrical interfaces |
6. WAN interface: VDSL interface NOTE:
This interface supports the dying gasp function. |
7. Two FXS interfaces |
8. WAN interface: GE combo interface |
9 Two Wi-Fi antenna interfaces |
10. Two LTE antennas |
11. Two SIM card slots |
- |
Slot Layout
| Slot Type | Slot ID | Slot Direction | Remarks |
|---|---|---|---|
| SIM card slot | SIM1 | - | Two SIM card slots are supported.
|
| SIM card slot | SIM2 | - | Two SIM card slots are supported.
|
Ports
| Port | Connector Type | Description | Available Components |
|---|---|---|---|
| Console interface | RJ45 | The console interface can connect to an operation terminal for onsite configuration.
|
|
| LAN interfaces: four GE electrical interfaces | RJ45 | A GE electrical interface (10/100/1000 Mbit/s auto-sensing) transmits and receives services at 10 Mbit/s, 100 Mbit/s, or 1000 Mbit/s.
NOTE:
GE0 is a management interface and is used for web-based management and email-based deployment. All LAN-side GE interfaces can be configured as WAN-side interfaces. |
|
| WAN interfaces: GE combo interfaces | GE electrical interface: RJ45 GE optical port: LC/PC |
A GE combo interface consists of an optical Ethernet interface and an electrical Ethernet interface on the panel. The two interfaces have only one internal forwarding interface. The electrical and optical interfaces are multiplexed, and only either of them can work at a time. When either of the Ethernet interfaces is working, the other interface is shut down.
NOTE:
By default, a combo interface works in auto mode and automatically works as an optical or electrical interface. |
The following optical modules are supported: |
| Two Wi-Fi antenna interfaces | RP-SMA-K (screw threads outside and a pin inside) | A Wi-Fi antenna interface connects to a Wi-Fi antenna to transmit and receive data.
NOTE:
Wi-Fi antennas have been installed on Wi-Fi interfaces of a router before delivery. If the router uses channels 12 and 13 of the 2.4 GHz band to provide Wi-Fi service, connect an LTE remote antenna to the corresponding LTE antenna interface. |
Wi-Fi antenna |
| WAN interface: VDSL interface | RJ11 | A VDSL interface transmits service data from a LAN to an upstream device at a high speed. Standards compliance:
|
Universal telephone line |
| Two FXS interfaces | RJ11 | An FXS interface is an analog subscriber line interface and can connect to an analog phone or fax machine.
|
Universal telephone line |
| 2 LTE antenna interfaces | SMA-K (screw threads outside and a hole inside) | LTE antenna interfaces of a router include a MAIN interface (for the primary antenna) and a DIV interface (for the secondary antenna). The primary and secondary antennas work together. The primary antenna transmits and receives LTE signals, and the secondary antenna only receives LTE signals to help improve the downlink rate. Interface standards and supported frequency bands: EC200T-EH:
Supported rates:
NOTE:
LTE whip antennas for LTE antenna interfaces are delivered with the installation accessory package. LTE indoor remote antennas can be installed on LTE antenna interfaces. |
LTE antenna |
| USB interface 2.0 (host) | USB 2.0 Type A | A USB interface provides up to 480 Mbit/s upload and download rates.
NOTE:
This interface can be used only for USB-based deployment. |
USB 2.0-compliant USB flash drive |
Indicators
1. PWR indicator |
2. SYS indicator |
3. USB indicator |
4. iNET indicator |
5. CTRL indicator |
6. LAN (GE0 to GE3) interface indicators |
7. GE combo interface indicator (GE4) |
8. WLAN 2.4G (effective when working on the 2.4 GHz band) |
9. WLAN 5G (effective when working on the 5 GHz band) indicator |
10. VDSL interface indicator |
11. FXS interface indicators (FXS0 to FXS1) |
12. WWAN indicator |
13. RSSI indicator |
- |
- |
| Silkscreen | Name | Color | Status | Description |
|---|---|---|---|---|
| PWR | PWR indicator | Green | Steady on | The system power supply is normal. |
| - | Off | The system power is off. | ||
| SYS | SYS indicator | Green | Slow blinking | The system is running properly. |
| Green | Fast blinking | The system is being powered on or restarting. | ||
| Red | Steady on | A fault that affects services has occurred. The fault cannot be rectified automatically and requires manual intervention. | ||
| - | Off | The system software is not running or is being reset. | ||
| USB | USB indicator | Green | Steady on | The system has been upgraded or configured using a USB flash drive. |
| Green | Blinking | The system is being upgraded or configured using a USB flash drive. | ||
| Red | Steady on | The system fails to be upgraded or configured using a USB flash drive. | ||
| - | Off | No USB flash drive is connected, the USB interface has failed, or the indicator has failed. | ||
| iNET | iNET indicator | Green | Steady on | The network service has been established. |
| - | Off | The network service is unavailable. | ||
| CTRL | CTRL indicator | Green | Steady on | The device has been connected to the controller. |
| - | Off | The device is not connected to the controller. | ||
| WWAN | WWAN indicator | Green | Steady on | A 4G/3G/2G connection has been established or is active. |
| Green | Blinking | Data is being transmitted or received over the 4G/3G/2G connection. | ||
| - | Off | The 4G/3G/2G connection has not been established or is inactive. | ||
| RSSI | RSSI indicator | Green | Steady on | The 4G/3G/2G signal strength is high. |
| Green | Fast blinking | The 4G/3G/2G signal strength is medium. | ||
| Green | Slow blinking | The 4G/3G/2G signal strength is low. | ||
| - | Off | No 4G/3G/2G signal is available. | ||
| GE4 | GE combo interface indicator (GE4) | Green | Steady on | A link has been established on the corresponding GE combo interface. |
| Green | Blinking | Data is being transmitted or received on the corresponding GE combo interface. | ||
| - | Off | No link is established on the corresponding GE combo interface. | ||
| VDSL | VDSL interface indicator | Green | Steady on | A link has been established on the corresponding VDSL interface. |
| Green | Blinking | A link is activating on the corresponding VDSL interface. | ||
| - | Off | No link is established on the corresponding VDSL interface. | ||
| FXS0 to FXS1 | FXS interface indicators (FXS0 to FXS1) | Green | Steady on | The corresponding FXS channel is being occupied by a call. |
| - | Off | The corresponding FXS channel is idle. | ||
| GE0 to GE3 | LAN interface indicator (GE0 to GE3) | Green | Steady on | A link has been established on the corresponding LAN interface. |
| Green | Blinking | Data is being transmitted or received on the corresponding LAN interface. | ||
| - | Off | No link is established on the corresponding LAN interface. | ||
| 2.4G | WLAN 2.4G indicator (effective when working on the 2.4 GHz band) | Green | Steady on | A WLAN link has been established on the corresponding interface. |
| Green | Blinking | The WLAN link is transmitting data. | ||
| - | Off | The WLAN link is shut down. | ||
| 5G | WLAN 5G indicator (effective when working on the 5 GHz band) | Green | Steady on | A WLAN link has been established on the corresponding interface. |
| Green | Blinking | The WLAN link is transmitting data. | ||
| - | Off | The WLAN link is shut down. |
Technical Specifications
| Item | Specification |
|---|---|
| Installation type |
|
| Dimensions without packaging (H x W x D) [mm(in.)] |
|
| Dimensions with packaging (H x W x D) [mm(in.)] | 90 mm x 370 mm x 297 mm (3.54 in. x 14.57 in. x 11.69 in.) |
| Chassis height [U] | 1 U |
| Weight with packaging [kg(lb)] | 1.31 kg (2.89 lb) |
| Weight without packaging [kg(lb)] | 0.69 kg (1.52 lb) |
| CPU | 1.1 GHz, 2 Cores |
| Memory | 1 GB |
| NAND Flash | 1 GB |
| Console port | RJ45 |
| RTC | Supported |
| Maximum power consumption [W] | 17 W |
| Power supply mode | External AC |
| Number of power modules | 1 |
| Rated input voltage [V] | 110 V to 220 V, 50 Hz/60 Hz |
| Input voltage range [V] | 90 V to 270 V, 45 Hz to 65 Hz |
| Maximum input current [A] | 0.8 A |
| Maximum output power [W] | 24 W |
| Type of fans | None |
| Number of fan modules | 0 |
| Heat dissipation mode | Natural heat dissipation |
| Redundant power supply | Not supported |
| PoE | Not supported |
| Noise at normal temperature (acoustic power) [dB(A)] | 0 (Natural heat dissipation) |
| Long-term operating temperature [°C(°F)] | 0°C to 40°C (32°F to 104°F) NOTE:
When the altitude is 1800 m-5000 m (5906 ft.-16404.2 ft.), the highest operating temperature reduces by 1°C (1.8°F) every time the altitude increases by 220 m (722 ft.). |
| Storage temperature [°C(°F)] | -40°C to +70°C (-40°F to +158°F) |
| Long-term operating relative humidity [RH] | 5% RH to 95% RH, non-condensing |
| Long-term operating altitude [m(ft.)] | < 5000 m (16404.2 ft.) |
| MTBF [year] | 51.63 year |
| MTTR [hour] | 2 hour |
| Availability | 0.9999955776 |