Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Crossover ISDN S/T Cable
Connection
A crossover ISDN S/T cable is connected as follows:
- The RJ45 male plug is connected to the ISDN interface on a 2BST interface card.
- The other RJ45 female socket is connected to a network device.
Appearance and Structure
Figure 7-20 Structure of the Crossover ISDN S/T Cable
![]()
A 2BST interface card works in network termination (NT) mode and supports only voice services, but not data services. The 2BST interface card uses a crossover ISDN S/T cable (adapter cable). A straight-through cable can be used as an extension cable for the crossover ISDN S/T cable.
Pin Assignments
Table 7-67 shows the pin assignments of a crossover ISDN S/T cable.
Table 7-67 Pin assignments of a crossover ISDN S/T cable
X1 (TE) |
Signal |
X2 (NT) |
|---|---|---|
1 |
- |
1 |
2 |
- |
2 |
3 |
Tx+ |
4 |
4 |
Rx+ |
3 |
5 |
Rx- |
6 |
6 |
Tx- |
5 |
7 |
- |
7 |
8 |
- |
8 |
In a crossover ISDN S/T cable, pins 4 and 5 are used to transmit signals, and pins 3 and 6 are used to receive signals.
Technical Specifications
Table 7-68 Technical specifications of the Crossover ISDN S/T Cable
| Item | Details |
|---|---|
| Part Number | 04070137 |
| Model | S-8-0.53-RJ45-3 |
| Description | Signal Cable,ISDN-NT,3m,MP8-IV,CC4P0.5P430U(S),MP8(S)-III |
| Cable length [m] | 3 m |
| Connector type X1 | RJ45 |
| Connector type X2 | RJ45 |