No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling IP Routing for a Bridge Group

Enabling IP Routing for a Bridge Group

Context

IP routing enables a bridge group to bridge and route packets. If IP routing is not enabled, all protocol packets can only be bridged. After IP routing is enabled, specified protocol packets can be bridged or routed depending on the configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run bridge bridge-id

    The bridge group view is displayed.

  3. Run routing ip

    IP routing is enabled for the bridge group.

    The IP routing function cannot be configured if any of member interfaces in the bridge group has an IP address. Before configuring the IP routing function, delete the IP addresses of these member interfaces.

  4. Run quit

    Return to the system view.

  5. Run interface bridge-if bridge-id

    A Bridge-if interface is created and the Bridge-if interface view is displayed.

  6. Run ip address ip-address { mask | mask-length }

    An IP address is configured for the Bridge-if interface.

  7. (Optional) Run mac-address mac-address

    A MAC address is configured for the Bridge-if interface.

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 58117

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next