No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Remote Bridging

Remote Bridging

If LANs in different geographical locations need to communicate with each other at the link layer, remote bridging can be used to bridge the LANs.

Figure 14-6  Networking diagram for remote bridging

As shown in Figure 14-6, Router A and Router B are connected with each other over a network. PC2, PC4, PC5, and PC7 belong to four different LANs (LAN 2, LAN 1, LAN 4, LAN 3) on different network segments. LAN 1 needs to communicate with LAN 3, and LAN 2 with LAN 4.

Bridges 1 and 2 are created on Router A and Router B, respectively. Ethernet2/0/1 and Serial 1/0/0 on both Router A and Router B are added to bridge 1; Ethernet2/0/2 and Serial 1/0/1 on both Router A and Router B are added to bridge 2. In this manner, the preceding communication requirement can be met.

Other types of links, such as Ethernet, Point-to-Point Protocol (PPP), Asynchronous Transfer Mode (ATM), can also be used for remote bridging.

To support remote bridging, transparent bridging provides the following functions:

  • Allow Ethernet interfaces, Ethernet sub-interfaces, VLANIF, VT, Serial, Serial sub-interfaces, Dialer, PON interfaces, ATM interfaces, ATM sub-interfaces, MFR interfaces, MFR sub-interfaces to be added to bridge groups.

  • Link encapsulation protocols such as Ethernet, PPP, PPP0A, PPPOE, PPPOEOA, and ATM.

  • 802.1Q VLAN ID transparent transmission.

  • Bridging IP and non-IP packets.

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 58976

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next