No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding a LAN-side Interface to a Bridge Group

Adding a LAN-side Interface to a Bridge Group


A bridge group is a virtual group. It can forward packets only after interfaces have been added to the group.

As shown in Figure 14-17, the following methods can be used to add users to a bridge group:
  • Directly add users to the bridge group. User 1 uses this method.
  • Use a VLAN to add users to the bridge group. Create a VLAN on a bridge and add users to the VLAN. Users then connect to the bridge group through the VLANIF interface. User 2 and User 3 use this method.
  • Use Ethernet sub-interfaces to add users to the bridge group. This method is used when flows on a physical interface need to be differentiated using sub-interfaces. User 4 uses this method.
Figure 14-17  Networking diagram for adding users to bridge groups

Perform the following steps on the user-side interface of the device.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The user-side interface view is displayed.

  3. Run bridge bridge-id

    An interface is added to a bridge group.

    A maximum of 20 interfaces can be added to a bridge group. Different types of interfaces can be added to the same bridge group. Layer 2 interfaces cannot be added to a bridge group.

    Ethernet sub-interfaces, XGE sub-interfaces and GE sub-interfaces configured to terminate QinQ tags do not support transparent bridging.

Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 63485

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next