No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Layer 2 Protocol Transparent Transmission on an Interface

Enabling Layer 2 Protocol Transparent Transmission on an Interface

Context

Perform the following operations on PEs based on the required Layer 2 protocol transparent transmission mode.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The network-side interface view is displayed.

  3. Run l2protocol-tunnel { protocol-type | user-defined-protocol protocol-name } enable

    Layer 2 protocol transparent transmission is enabled on the interface.

    By default, Layer 2 protocol transparent transmission is disabled on the interface.

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 56455

Downloads: 38

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next