No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding a WAN-side Interface to a Bridge Group

Adding a WAN-side Interface to a Bridge Group

Context

Two devices can be connected using different types of intermediate links, such as Ethernet, PPP, to bridge data between different LANs.

To implement remote bridging between different LANs, add the user-side interface connecting to a LAN and the network-side interface connecting to the intermediate link to the same bridge group.

Perform the following steps on the devices at both ends of the intermediate link.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the network-side interface is displayed.

  3. Perform the following operations depending on the type of interface:

    • Add an Ethernet interface to a bridge group.

      1. Run bridge bridge-id

        The Ethernet interface is added to the bridge group.

    • Add a PPP interface to a bridge group.

      1. Run link-protocol ppp

        PPP is enabled on the interface.

      2. Run bridge bridge-id

        The PPP interface is added to the bridge group.

    • Add an IMA-Group interface to a bridge group.

      1. Run bridge bridge-id

        The IMA-Group interface is added to the bridge group.

      2. Run pvc { { pvc-name [ vpi/vci ] | vpi/vci } | { start-vpi/start-vci end-vpi/end-vci } }

        The PVC view is displayed.

      3. Run map bridge broadcast

        The PVC is configured to receive and send bridging packets.

    The number of interfaces that can be added to a bridge group depends on device models:
    • AR650 and AR1600 series: 128
    • AR6100 series: 20
    Interfaces of different types can be added to the same bridge group, but Layer 2 interfaces cannot be added to a bridge group.

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 62919

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next