No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Proposal/Agreement Mechanism

Configuring a Proposal/Agreement Mechanism

Context

The rapid transition mechanism is also called the Proposal/Agreement mechanism. All switching devices support the following modes:

  • Enhanced mode: The current interface counts the root port calculation when it computes the synchronization flag bit.
    • An upstream device sends a Proposal message to a downstream device, requesting rapid status transition. After receiving the message, the downstream device sets the port connected to the upstream device as a root port and blocks all non-edge ports.

    • The upstream device then sends an Agreement message to the downstream device. After the downstream device receives the message, the root port transitions to the Forwarding state.

    • The downstream device responds to the Proposal message with an Agreement message. After receiving the message, the upstream device sets the port connected to the downstream device as a designated port, and the designated port transitions to the Forwarding state.

  • Common mode: The current interface ignores the root port when it computes the synchronization flag bit.
    • An upstream device sends a Proposal message to a downstream device, requesting rapid status transition. After receiving the message, the downstream device sets the port connected to the upstream device as a root port and blocks all non-edge ports. The root port then transitions to the Forwarding state.

    • The downstream device responds to the Proposal message with an Agreement message. After receiving the message, the upstream device sets the port connected to the downstream device as a designated port. The designated port then transitions to the Forwarding state.

When Huawei devices are connected to non-Huawei devices, select the same mode as that used on non-Huawei devices.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The Ethernet interface view is displayed.

  3. Run stp no-agreement-check

    The common rapid transition mechanism is configured.

    By default, the interface uses the enhanced rapid transition mechanism.

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 62881

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next