No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How to Verify That an Interface Is Added to a VLAN

How to Verify That an Interface Is Added to a VLAN

Run the display vlan vlan-id command and verify that the interface is listed in the command output.

For example, interface Ethernet2/0/0 is added to VLAN 10.

<Huawei> display vlan 10
* : management-vlan
VLAN ID Type         Status   MAC Learning Broadcast/Multicast/Unicast Property 
10      common       enable   enable       forward   forward   forward default
Untagged      Port: Ethernet2/0/0
Active Untag  Port: Ethernet2/0/0
Interface                   Physical
Ethernet2/0/0               UP
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 56876

Downloads: 38

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next