No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Open-Ring Networking

Open-Ring Networking

As shown in Figure 12-9, Router1 to Router5 form an open ring to access a Layer 2 network. The two edge devices on the Layer 2 network, that is, Router1 and Router5, are not directly connected. This networking is called open-ring networking. The open-ring networking is at the access layer and is used to transparently transmit Layer 2 unicast and multicast services. When SEP runs at the access layer, redundancy protection switching can be implemented at the access layer and topology of the SEP segment can be displayed.

On an open-ring network, edge interfaces are located on the two edge devices in the SEP segment.

Figure 12-9  Networking diagram of an open ring running SEP

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 64336

Downloads: 41

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next