No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - Ethernet Switching

AR650, AR1600, and AR6100 V300R003

This document describes how to configure the components for LAN services, including link aggregation groups, VLANs, voice VLANs, MAC address tables, transparent bridging, as well as GVRP, STP/RSTP, and MSTP protocols.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for QinQ

Licensing Requirements and Limitations for QinQ

This section describes the points of attention when configuring QinQ.

Involved Network Elements

None

Licensing Requirements

QinQ is a basic feature of a router and is not under license control.

Feature Limitations

When deploying QinQ on the router, pay attention to the following:

  • Before configuring QinQ on an interface, add the interface to a network bridge. If the interface is deleted from the network bridge, the QinQ configuration is also deleted from the interface.
  • You can configure only QinQ, selective QinQ, or VLAN mapping on a sub-interface.
NOTE:

AR650, AR1600, and AR6100 series do not support selective QinQ stacking on a Layer 2 interface.

Download
Updated: 2019-04-12

Document ID: EDOC1100041791

Views: 57717

Downloads: 40

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next