No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR650, AR1600, and AR6100 V300R003

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of IPSec Tunnel Establishment Using a Virtual Tunnel Interface

Verifying the Configuration of IPSec Tunnel Establishment Using a Virtual Tunnel Interface


The configurations of the IPSec tunnel that is established using a virtual tunnel interface are complete.


  • Run the display ipsec proposal [ brief | name proposal-name ] command to check IPSec proposal information.
  • Run the display ipsec profile [ brief | name profile-name ] command to check IPSec profile information.
  • Run the display ike identity [ name identity-name ] command to check IKE identity information.
  • Run the display ipsec sa [ brief | duration | policy policy-name [ seq-number ] | remote ipv4-address ] command to check IPSec SA information.
  • Run the display ipsec global config command to check global IPSec configuration.
  • Check IKE information. See Verifying the IKE Configuration.
Updated: 2019-04-12

Document ID: EDOC1100041799

Views: 31431

Downloads: 43

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next