No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR650, AR1600, and AR6100 V300R003

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling Dependency Between IPSec SA and IKE SA During IKEv1 Negotiation

(Optional) Enabling Dependency Between IPSec SA and IKE SA During IKEv1 Negotiation

Context

By default, no dependency exists between IPSec SA and IKE SA, that is, the two SAs can be deleted separately. If the IKE SA is deleted but the corresponding IPSec SA still exists, traffic forwarding will be effected. You can enable dependency between IPSec SA and IKE SA to ensure that an IPSec SA is deleted when its corresponding IKE SA is deleted.

The system supports two configuration modes: global configuration and configuration on an IKE peer. Parameters configured on an IKE peer take precedence over those configured globally. When parameters are not configured on an IKE peer, the global parameter settings take effect.

Procedure

  • Global configuration
    1. Run system-view

      The system view is displayed.

    2. Run ikev1 phase1-phase2 sa dependent

      Dependency between IPSec SA and IKE SA during IKEv1 negotiation is enabled.

      By default, no dependency exists between IPSec SA and IKE SA during IKEv1 negotiation.

  • Configuration on an IKE peer
    1. Run system-view

      The system view is displayed.

    2. Run ike peer peer-name

      An IKE peer view is displayed.

    3. Run ikev1 phase1-phase2 sa dependent

      Dependency between IPSec SA and IKE SA during IKEv1 negotiation is enabled.

      By default, no dependency exists between IPSec SA and IKE SA during IKEv1 negotiation.

      NOTE:

      V300R003C10 and later versions support this function.

Download
Updated: 2019-04-12

Document ID: EDOC1100041799

Views: 31628

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next