No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR650, AR1600, and AR6100 V300R003

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Auto VPN Configuration

Verifying the Auto VPN Configuration

After configuring auto VPN functions, verify the configuration.

Prerequisites

Auto VPN functions have been configured.

Procedure

  • Run the display site-tnp [ site-id ] command to check TNP information about a site.
  • Run the display dtls peer-connection configure [ device-id device-id ] command to check the DTLS connection configuration.
  • Run the display dtls peer-connection status [ device-id device-id ] command to check the running status of the DTLS connection.
  • Run the display dtls server status command to check the DTLS server status.
  • Run the display bgp [ tunnel-encap-ext | evpn ] peer [ [ ipv4-address ] verbose ] command to check information about BGP peers in the Tunnel-encap-ext or EVPN address family.
  • Run the display bgp [ tunnel-encap-ext | evpn ] routing-table peer statistics command to check statistics about advertised and received BGP routes in the Tunnel-encap-ext or EVPN address family.
  • Run the display bgp tunnel-encap-ext all routing-table command to check information about auto VPN routes.
  • Run the display bgp evpn all routing-table command to check information about EVPN routes.
  • Run the display evpn connection [ site-id ] command to check connection information about a site.
  • Run the display ms-channel command to check information about a primary channel.
Download
Updated: 2019-04-12

Document ID: EDOC1100041799

Views: 31606

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next