No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - VPN

AR650, AR1600, and AR6100 V300R003

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Layer 3 VXLAN Gateway

Configuring a Layer 3 VXLAN Gateway


A VBDIF interface is configured on a VXLAN Layer 3 gateway to forward packets across network segments. You do not need to create a VBDIF interface for communication between users in the same network segment.

If end users in a VXLAN site need to access the Internet or communicate with end users in another VXLAN site, a VXLAN Layer 3 gateway needs to be deployed to provide end users with Layer 3 services.

In Figure 7-16, after you create a logical Layer 3 VBDIF interface and configure an IP address for the VBDIF interface, the VBDIF interface functions as the gateway for tenants in the BD to forward packets at Layer 3 based on the IP address. Each BD has only one VBDIF interface.

To ensure that users in different network segments can communicate with each other, ensure that the default gateway address is the IP address of the VBDIF interface on the VXLAN Layer 3 gateway.

Figure 7-16  Layer 3 VXLAN gateway networking


  1. Run system-view

    The system view is displayed.

  2. Run interface vbdif bd-id

    A VBDIF interface is created and the VBDIF interface view is displayed.


    The number of the VBDIF interface must match an existing BD ID.

  3. Run ip address ip-address { mask | mask-length } [ sub ]

    An IP address is configured for the VBDIF interface to implement Layer 3 communication.

    By default, no IP address is configured for a VBDIF interface.

Updated: 2019-04-12

Document ID: EDOC1100041799

Views: 34379

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next