No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - VPN

AR650, AR1600, and AR6100 V300R003

This document describes VPN features on the device and provides configuration procedures and configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring DSVPN QoS

(Optional) Configuring DSVPN QoS

Context

In a DSVPN scenario, the headquarters or branch can perform QoS classification on traffic of each tunnel for QoS management (traffic shaping and traffic policing). For example, the headquarters performs QoS management on branch traffic:
  • Configure an NHRP group on a branch.

    The NHRP packet sent by the branch carries the NHRP group name. After receiving the NHRP packet, the headquarters obtains the NHRP group name from the packet, records the NHRP group name in an NHRP peer entry, and generates the mapping between the IP address and QoS policy based on the locally configured NHRP group name and QoS policy. In this way, the headquarters can perform QoS management on branch traffic.

  • Create a matching rule based on the NHRP group in the QoS traffic classifier view on the headquarters and configure the corresponding QoS policy.

    The procedure is as follows:Configure a traffic classifier to match an NHRP group > Configure a traffic behavior > Configure a traffic policy > Apply the traffic policy.

    For details on QoS, see Huawei AR650&AR1600&AR6100 Series V300R003 Configuration Guide - QoS Configuring MQC.

NOTE:
V300R003C10 and later versions support this configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface tunnel interface-number

    The tunnel interface view is displayed.

  3. Run nhrp group group-name [ vendor-id vendor-id ]

    An NHRP group is configured.

    By default, no NHRP group is configured.

Download
Updated: 2019-04-12

Document ID: EDOC1100041799

Views: 34552

Downloads: 45

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next