No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Web-based Configuration Guide

AR650, AR1600, and AR6100 V300R003

This document describes how to configure and maintain your routers using the web platform.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
System Time

System Time

Context

To ensure communication between the router and other devices, set the accurate system time. The router support automatic system time synchronization with the NTP server or manual system time setting. The first method is recommended.

Procedure

  • Automatic synchronization
    1. Choose System Management > System Configuration > System Time, as shown in Figure 17-11.

      Figure 17-11  Automatic Synchronization page

    2. In the Date And Time Setting area, click Automatic Synchronization.
    3. Set NTP server 1 to the IP address of the NTP server 1.
    4. (Optional) Set NTP server 2 to the IP address of the NTP server 2.
    5. Click Apply.
    6. In the Information dialog box that is displayed, click OK.

    NOTE:

    The web platform supports two NTP servers and synchronizes the system time with the NTP server whose primary clock level is higher. For example, NTP1 has a higher primary clock level than NTP2, so the router synchronizes time with NTP1.

    If the primary clock level of the web platform is higher than the NTP servers, the web platform does not synchronize the system time with the NTP server.

  • Manual setting
    1. Choose System Management > System Configuration > System Time.
    2. In the Date And Time Setting area, click Manual Setting, as shown in Figure 17-12.

      Figure 17-12  Manual Setting page

    3. In the Date And Time Setting area, set the date and time.
    4. Click the Select time zone drop-down list box, and select the time zone.
    5. Click Apply.
    6. In the Information dialog box that is displayed, click OK.
Download
Updated: 2019-04-12

Document ID: EDOC1100041803

Views: 35979

Downloads: 100

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next