No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Web-based Configuration Guide

AR650, AR1600, and AR6100 V300R003

This document describes how to configure and maintain your routers using the web platform.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Mode Switching

Mode Switching


The VDSL interfaces can work in ATM or PTM mode and switch between these two modes. An ADSL interface works only in ATM mode.

The VDSL interfaces support the following transfer modes:
  • Asynchronous Transfer Mode (ATM): ATM cells are transmitted over VDSL lines.
  • Packet Transfer Mode (PTM): Ethernet frames are transmitted over VDSL lines.
The device functions as a CPE and must have the same interface transfer mode as the peer device.


  • Switching the transfer mode
    1. Choose WAN Access > DSL Interface to display the DSL Interface page.
    2. Click Mode Switching to display the Mode Switching tab page.
    3. Click in the Operation column of DSL Card List.
    4. Click OK.

      The configuration takes effect after several minutes.

Updated: 2019-04-12

Document ID: EDOC1100041803

Views: 36018

Downloads: 100

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next