No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Web-based Configuration Guide

AR650, AR1600, and AR6100 V300R003

This document describes how to configure and maintain your routers using the web platform.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Basic ACL Setting

Basic ACL Setting


After basic ACL rules are configured, routers classify IPv4 or IPv6 packets based on information such as source IP addresses, and time ranges in the packets.


  • Creating a basic ACL rule
    1. Access the Basic ACL Setting tab page.

      Log in to the web platform and choose Security > ACL > Basic ACL Setting, as shown in Figure 14-1.
      Figure 14-1  Basic ACL Setting

    2. Click Create in the Basic ACL Setting List area. Enter an ACL rule name in the Create Basic ACL Setting dialog box, as shown in Figure 14-2. To create a basic ACL4 rule, click IPv4; to create a basic ACL6 rule, click IPv6.

      Figure 14-2  Create Basic ACL Setting


      The value of ACL name is a string of 1 to 32 characters without spaces or question marks (?) and must start with a letter.

    3. Click OK.
    4. Click Add rules and set parameters to add basic ACL rules in the ACL rule entry, as shown in Figure 14-3. Table 14-1 describes the parameters.

      Figure 14-3  Add rules

    5. Click . To delete a basic ACL rule, click .

      Table 14-1  Basic ACL rule parameters



      Rule number

      ACL rule number.


      If you do not specify a rule number, the system allocates a number for the rule. The rule number cannot be changed.


      Whether to permit or deny packets.

      Source IP/Prefix Length(Wildcard)

      Source IP address of packets to be matched by the ACL rule.

      • When the ACL type is IPv4, enter the source IP address and wildcard both in dotted decimal notation.

      • When the ACL type is IPv6, enter the source IP address and prefix length. The source IP address is in colon hexadecimal notation. The prefix length is an integer that ranges from 1 to 128.

      Time Range

      Name of a time range during which ACL rules take effect.


      The time range name is displayed on the Time Range tab page.

      If this parameter is not specified, ACL rules are always valid.

  • Deleting a basic ACL rule
    1. Access the Basic ACL Setting tab page.

      Log in to the web platform and choose Security > ACL > Basic ACL Setting.

    2. Click next to a basic ACL rule.
    3. In the dialog box that is displayed, click OK.
Updated: 2019-04-12

Document ID: EDOC1100041803

Views: 38634

Downloads: 103

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next