No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R010C00SPC200, 300, and 500 Local HA System Software Installation Guide (SUSE Linux + Oracle + Veritas) 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging in to the SUSE Linux Server

Logging in to the SUSE Linux Server

This section describes the methods for logging in to the Linux server because some operations in the installation process are performed on the GUI.

The management network port supports a low resolution. After logging in to the server through the management port, a user cannot view all information on the page. In this case, the user can run the yast2 -l command to list all modules that are supported. Then the user can run the yast2 Module name command to directly invoke the corresponding module. For example, the yast2 lan and yast2 remote commands can be run to configure the network and enable the remote VNC, respectively.

Updated: 2019-10-30

Document ID: EDOC1100044372

Views: 29423

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next