No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R010C00SPC200, 300, and 500 Local HA System Software Installation Guide (SUSE Linux + Oracle + Veritas) 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Do If Heartbeat IP Connection Between a Remote Server and the Local Two-Node Cluster Is Interrupted

How Do I Do If Heartbeat IP Connection Between a Remote Server and the Local Two-Node Cluster Is Interrupted

Answer

The following uses bond1 as an example to describe how to check a heartbeat connection.

  1. Log in to the active and standby hosts as the root user and run the following command to check the network cable connection.

    # ethtool bond1

    If the following information is displayed, the cables are correctly connected. If the following information is not displayed, connect the network cables correctly.

    Settings for bond1:  Link detected: yes
  2. Run the following command on the active and standby servers as the root user to check whether the heartbeat network port is enabled:

    # ifconfig | grep bond1

    If no information is displayed, the heartbeat network port is disabled.

    Run the ifconfig bond1 up command. If the following information is displayed, the heartbeat network port is enabled.

     bond1     Link encap:Ethernet  HWaddr A4:DC:BE:1E:5D:F8
  3. Check whether the heartbeat IP addresses of the active and standby hosts are on the same network segment.

    Configure heartbeat IP addresses on the same network segment for the active and standby hosts.

Translation
Download
Updated: 2019-10-30

Document ID: EDOC1100044372

Views: 29342

Downloads: 26

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next