No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R010C00 Maintenance Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Restoring the Entire eSight System (Including Installing a RAID Driver)

Restoring the Entire eSight System (Including Installing a RAID Driver)

For the 2288H V5 server, the RAID controller card cannot be identified by the official Windows installation disc. Therefore, you need to install a RAID driver during the restoration.

Procedure

  1. Restore the operating system.

    NOTE:

    Do not cancel the operation during the restoration.

    To restore the operating system, insert the standard operating system disc delivered with the device and boot the operating system from the drive.

    1. Press any key when information shown in the following figure is displayed.

    2. Press Enter when information shown in the following figure is displayed.

    3. Contents in the disc are automatically loaded and no operation is needed here.

    4. Click Next.

    5. Click Repair your computer.

    6. Select Troubleshoot.

    7. Select System Image Recovery.

    8. Select Windows Server 2012 R2.

  2. Some devices cannot identify hard disks because the disc does not contain the corresponding driver. Therefore, you need to install a RAID driver. In the dialog box that is displayed, click Cancel.

    1. In the dialog box that is displayed, click Next.

    2. In the dialog box that is displayed, click Advanced.

    3. In the dialog box that is displayed, click Install a driver.

    4. After the following dialog box is displayed, remove the original operating system disc and insert the 2288H V5 driver disc. (Download the driver package from http://support.huawei.com/enterprise/en/software/22895464-SW2000006968, decompress the package to obtain the RAID controller driver 3508_win2k12r2_x86_64_7.703.06.00.img, and burn the file to the disc.) Then click OK.

    5. Open the driver installation disc in This PC.

    6. Select the installation information file megasas35 and click Open.

    7. Click Add Drivers.

    8. The system starts to install the RAID controller card driver.

  3. Load the image for restoration. After the driver is installed, the device that contains the image is automatically discovered. Select the disk and click Next.

    1. Select the backup record to be restored and click Next.

    2. Click Next.

    3. Click Finish.

    4. Click Yes.

    5. System restoration starts.

      After the restoration is complete, restart the system.

Translation
Download
Updated: 2019-06-30

Document ID: EDOC1100044373

Views: 25002

Downloads: 74

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next