No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R010C00SPC200, 300, and 500 Operation Guide 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings and Device Configurations

Default Settings and Device Configurations

Before using the Telepresence Conference, you must learn about the Telepresence Conference default settings and the Device Configurations to ensure smooth operations.

Specifications Calculation Supported by the eSight

  • Latency: interval for receiving a packet minus the interval for sending the packet.
  • Jitter: interval for receiving two consecutive packets minus the interval for sending them.
  • Packet loss ratio = (Total number of sent packets - Total number of received packets)/Total number of packets x 100%

Test Instances and Counters Supported by the eSight

Table 16-14 describes test instances and counters supported by the eSight.

Table 16-14 Test instances and counters supported by the eSight

Counter

ICMP Echo

UDP Jitter

Packet loss rate

Y

Y

Max. RTD (ms)

Y

Y

Average RTD (ms)

Y

Y

Average jitter

N

Y

Number of timeouts

Y

Y

Max. unidirectional delay from source to destination (ms)

N

Y

Max. unidirectional delay from destination to source (ms)

N

Y

Average delay from source to destination (ms)

N

Y

Average delay from destination to source (ms)

N

Y

Average jitter from source to destination (ms)

N

Y

Average jitter from destination to source (ms)

N

Y

Packet loss rate from source to destination (%)

N

Y

Packet loss rate from destination to source (%)

N

Y

MOS value

N

Y

Device Configuration

To perform test instances in eSight, you must perform the following settings listed in Table 16-15.

Table 16-15 Device configuration

Test Instance

Device Configuration Requirements

ICMP Echo

The source and destination devices can ping successfully.

UDP Jitter

The UDP service must be enabled on the destination device.

Run the following commands to start the UDP service:

<Huawei> system-view

[Huawei] nqa-server udpecho 10.137.61.39 33434

In the command, 10.137.61.39 is the destination device IP address and 33434 is the UDP port number.

Translation
Download
Updated: 2019-09-12

Document ID: EDOC1100044378

Views: 82438

Downloads: 403

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next