No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R010C00SPC200, 300, and 500 Operation Guide 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding Devices to eSight

Adding Devices to eSight

After devices are added to eSight, you can create iPCA monitoring tasks to monitor network resources and service quality.




1. Set protocol parameters on the device: SNMP.

SNMP parameters: They are used to add devices to eSight.

For details about how to configure the SNMP protocol on the device, see Configuring the SNMP Protocol on Devices.

2. Add devices to eSight.

Select a proper device addition mode based on the site requirements.

For details about how to add devices to eSight, see Adding Devices to eSight.

Updated: 2019-09-12

Document ID: EDOC1100044378

Views: 83581

Downloads: 405

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next