No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R010C00SPC200, 300, and 500 Operation Guide 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NETCONF Protocol on Devices

Configuring the NETCONF Protocol on Devices

This section describes how to configure the NETCONF protocol on devices.

To enable eSight to manage network devices with higher security and scalability, you need to set NETCONF parameters on the network devices. NETCONF parameter settings on devices must be the same as those on eSight.

This section uses Huawei CloudEngine 12800 V200R002C20 as an example to describe basic commands for setting NETCONF parameters on the devices. For commands of other device models, see the device configuration manual.

<Device> system-view
[Device] interface GigabitEthernet 1/0/1   //Set GigabitEthernet 0/0/1 as the management interface of the NETCONF agent.
[Device-GigabitEthernet1/0/1] ip address 10.10.10.10 24   //Set the IP address of the management interface of the NETCONF agent to 10.10.10.10.
[Device-GigabitEthernet1/0/1] quit
[Device] ssh user netconfuser   //netconfuser is the user name configured when the device interconnection NETCONF protocol is configured on eSight. 
[Device] aaa
[Device-aaa] local-user netconfuser password irreversible-cipher Changeme123   //Changeme123 is the password configured when the device interconnection NETCONF protocol is configured on eSight. 
[Device-aaa] local-user netconfuser service-type ssh
[Device-aaa] local-user netconfuser level 15   //Set the NETCONF permission of the user to the highest level 15. You are advised to set the NETCONF permission based on the site requirements.
[Device-aaa] quit
[Device] ssh server cipher 3des_cbc aes128_cbc aes128_ctr aes256_cbc aes256_ctr arcfour128 arcfour256 blowfish_cbc des_cbc   //Set the encryption algorithm list on the SSH server.
[Device] ssh user netconfuser authentication-type password
[Device] ssh user netconfuser service-type snetconf
[Device] snetconf server enable
[Device] commit
Translation
Download
Updated: 2019-09-12

Document ID: EDOC1100044378

Views: 71667

Downloads: 378

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next