No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R010C00SPC200, 300, and 500 Operation Guide 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Upgrade Parameters

Setting Upgrade Parameters

You can set upgrade parameters for terminals to specify the concurrent number of the file server, number of automatic upgrade attempts, and upgrade timeout period. This prevents the batch upgrade of terminals from occupying too much resources and causing service exceptions.


  1. Choose Resource > Collaboration Resource from the main menu.
  2. In the navigation tree on the left, choose Terminal Device Management > System Configuration.
  3. Under Upgrade Parameter Configuration, set terminals upgrade parameters.

    • The default value of Automatic Re-execute Times is 3. If the upgrade fails, the terminals attempt to execute the upgrade again. When the number of automatic upgrade attempts reaches the specified threshold, the upgrade stops.
    • The default value of Upgrade Timeout Time is 30, in minutes. If a terminal does not report an upgrade success message to the eSight within the time specified by the Upgrade Timeout Time parameter, the eSight determines that the upgrade times out.
    • The default value of Concurrent value is 100. This parameter is used to specify the maximum number of terminals that can be concurrently upgraded.

  4. Click OK and click OK in the dialog box that is displayed.
  5. (Optional) In the Upgrade Task Automatic Retry area, set Automatic Retry to ON.


    If a terminal fails to be upgraded due to logout, it will automatically attempt to be upgraded after going online again.

Updated: 2019-09-12

Document ID: EDOC1100044378

Views: 69343

Downloads: 371

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next