No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R010C00SPC200, 300, and 500 Operation Guide 11

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding Devices to eSight

Adding Devices to eSight

After you add devices to eSight and enable required services on the devices, the SLA management function can be used to monitor the network quality.




1. Set protocol parameters on the device: SNMP

SNMP parameters: They are used to add devices to eSight.

For details about how to configure the SNMP protocol on the device, see Configuring the SNMP Protocol on Devices.

2. Adding Devices to eSight

After devices are added to eSight, you can create a periodic task or perform quick diagnosis to monitor the network performance, including the latency, jitter, and packet loss.

For details about how to add devices to eSight, see Adding Devices to eSight.

Updated: 2019-12-13

Document ID: EDOC1100044378

Views: 106278

Downloads: 461

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next