No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R010C00 Operation Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How to Configure Commands on Network Devices to Enable eSight to Parse Network Device Alarms

How to Configure Commands on Network Devices to Enable eSight to Parse Network Device Alarms

Question

How to configure commands on devices to enable the NMS to parse device alarms?

Answer

Run the snmp-agent trap source interface-type interface-number command to specify the source interface (device management interface) for sending Trap packets. Ensure that the IP address of the device management interface must be consistent with the IP address added to the NMS.

Translation
Download
Updated: 2019-06-30

Document ID: EDOC1100044378

Views: 59447

Downloads: 272

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next