No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

eSight V300R010C00 Operation Guide 07

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IP PBXs in Batches

Configuring IP PBXs in Batches

You can configure SIP trunks, active and standby servers, and software parameters for IP PBXs in batches.

Context

  • The process for configuring SIP trunks is as follows:
    1. (Optional) Add an index for routing processing failures.
    2. Add office direction selection codes.
    3. Add office directions.
    4. Add number change indexes.
    5. Add prefixes.
    6. Add peer devices.
    7. Add SIP trunk groups.
  • The process for setting IP PBXs as local gateways is as follows:
    1. Set the type of active and standby servers to Localgw.
    2. Set the IP address of active server nodes.
    3. Set the IP address of standby server nodes.
  • Software parameters in this topic indicate parameters for the call forwarding on offline (CFO) service.

Procedure

  1. Choose Resource > Collaboration Resource from the main menu.
  2. In the navigation tree, choose Network Element Device Management > Unified Communications > Service Configuration > IP PBX Batch Configuration.
  3. Optional: Add IP PBXs to the Devices to Configure area on the right.

    If the IP PBX you want to configure is included in the Devices to Configure area, skip this step.

    1. Click Add. The Select Resource window is displayed.
    2. Choose a subnet from the navigation tree on the left. All managed IP PBXs on this subnet are displayed on the right.
    3. Select multiple IP PBXs and click OK.

  4. Choose the parameters to be configured from the navigation tree on the left.
  5. Select IP PBXs to be configured in Devices to Configure.
  6. Configure the related parameters as prompted.

Result

The system starts to configure the selected IP PBXs in batches.

  • If the IP PBX is configured successfully, configuration success is displayed in the configuration result column.
  • If the IP PBX fails to be configured, the failure cause is displayed in the configuration result column.
Translation
Download
Updated: 2019-06-30

Document ID: EDOC1100044378

Views: 59375

Downloads: 270

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next