No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R010C00SPC200, 300, and 500 Operation Guide 09

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding a Microwave Device

Adding a Microwave Device

This section describes how to add a microwave device to eSight.


  • The devices have been installed and powered on.
  • The SNMP protocol has been configured for the devices.
  • You have obtained the network segment where the device is located, SNMP protocol port number, device account, authentication password, and encryption password.


  1. Choose Resource > Common from the menu bar.
  2. Choose Add Resource > Add Resource in the navigation tree on the left. The Add Resource page is displayed.
  3. Click Microwave Device and set device parameters as prompted to add a device.

    In the SNMP area, set Type to SNMPv3 and Privacy protocol to AES_128.


    Data integrity and confidentiality are two goals in the information security domain. Data integrity is guaranteed by the authorization authentication protocol and data confidentiality is guaranteed by the data encryption protocol.

Updated: 2019-09-12

Document ID: EDOC1100044378

Views: 70653

Downloads: 373

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next