Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Local System Settings
Before invoking the OpenAPI, the local information of the eSight must be set first.
- Choose System > System Settings > Northbound Integration from the main menu.
- Choose Local System Settings from the navigation tree.
- In the Global Parameters area, set System ID, System name, and IP address of the local system.
- System ID: indicates the ID of the system, which uniquely identifies the local system.
- You are advised to set IP address to the local IP address. If the system IP address is 127.0.0.*, the third-party system can access the system only through the system server.
- If the operating system has multiple IP addresses, configure the parameter to the IP address that can communicate to a third-party system physically. In the remote HA system, the IP address of the local system cannot be automatically switched after an active/standby switchover.
- In the HTTPS Interface area, set Basic Parameters and Notification Parameters.
Heartbeat interval: specifies the interval for the third-party system to check whether the eSight is online.
- Click Apply.
