No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


eSight V300R010C00SPC200, 300, and 500 Self-Service Integration Guide 10

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Heartbeat Management Interfaces

Heartbeat Management Interfaces

Setting the Heartbeat Period


The third-party system can change the interval at which heartbeat traps are reported.

MIB Definition

The MIB OID is

The complete path is as follows:


Node Name

Data Type

Maximum Access Rights





Set the heartbeat period.

Setting Method

The third-party system sets iMAPNorthboundHeartbeatSvcReportInterval to an integer ranging from 3 to 3600 to change the heartbeat period.

Receive Heartbeat Notification Traps

The SNMP NBI of the eSight can send heartbeat notification traps to the upper-layer NMS.

With the trap receiving IP address and port configured, the upper-layer NMS will receive heartbeat notification traps from eSight within a specified heartbeat period. For details about heartbeat notification traps, see section Heartbeat Trap.

If the upper-layer NMS receives no heartbeat notification traps from eSight within a specified heartbeat period, the upper-layer NMS is not properly connected to eSight. If the upper-layer NMS receives heartbeat notification traps from eSight within a specified heartbeat period, the upper-layer NMS is properly connected to the eSight.

To implement the heartbeat notification service, perform the following steps:

  1. On the upper-layer NMS, configure the IP address and port for receiving traps and the heartbeat period (default period: 60s).
  2. Enable the upper-layer NMS to receive heartbeat notification traps.

For the detailed configuration method, see section Preparation.

Updated: 2019-10-30

Document ID: EDOC1100044386

Views: 17100

Downloads: 84

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next