Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Commissioning the eSight
To allow the eSight to manage the network, you must commission the eSight before using the eSight to manage devices and configuring services.
If you use a graphical terminal, such as Xshell, to remotely log in to the server, run the following command to set the environment variable:
- View the value of the environment variable DISPLAY.
echo $DISPLAY
The following information is displayed:
:0.0
- Set the value of the environment variable DISPLAY.
export DISPLAY=IP address of the graphical terminal:0.0
- Preparing Commissioning Tools
Before commissioning eSight, prepare necessary tools. - Enabling Ports on Firewalls
If eSight is not in the same network segment as the NEs, upper-layer NMSs, SMS gateways, and mail servers, you must enable ports on firewalls before the commissioning. - Configuring System Services
Before using eSight, you need to configure system services based on the site requirements to ensure that eSight functions properly. - Commissioning eSight Components
This section describes how to configure components so that services can be commissioned and configured. - Commissioning eSight Functions
After adding devices to eSight, you need to commission eSight functions such as the network monitoring, device management, service management, authentication server, and northbound interface. - Performing Security Settings
Security settings must be performed, such as changing the user password, replacing the security certificate, and setting the user security policy.