Setting the LAN Parameters

Enterprise

Worldwide

On the web interface, choose System Settings > Network > LAN and set required parameters, as shown in Figure 2-27.

Figure 2-27 Setting the LAN parameters

Table 2-12 describes the key LAN parameters. For the parameters that are not listed here, use their default values.

Table 2-12 LAN parameters

Parameter	Value	Remarks
Connection type	Dynamic IP	Default value. The options are as follows: Static IP: If you select Static IP, you need to set Local IP address, Subnet mask, and Gateway address. Dynamic IP: If you select Dynamic IP, the TE10 automatically obtains an IP address from the DHCP server. Confirm the connection type with administrator.

Parameter

Value

Remarks

Connection type

Dynamic IP

Default value.

The options are as follows:

Static IP: If you select Static IP, you need to set Local IP address, Subnet mask, and Gateway address.
Dynamic IP: If you select Dynamic IP, the TE10 automatically obtains an IP address from the DHCP server.

Confirm the connection type with administrator.

If you want to configure an IPv6 address, set IPv6 to Enable first.

This document describes how to config the Videoconferencing Endpoint.