No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Web Online Help

TE10 Videoconferencing Endpoint V600R019C00

This document describes the help information on the web interface.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Upgrade Parameters

Setting Upgrade Parameters

Your endpoint supports automatic and manual upgrades. With the automatic upgrade function enabled, your endpoint obtains upgrade files from a specified server and installs the upgrade files when the upgrade interval arrives.

Procedure

  1. Choose System Settings > Installation.

    The Installation page is displayed.

  2. Click Auto Upgrade Settings.

    The Auto Upgrade Settings page is displayed.

  3. Set the upgrade parameters listed in Table 3-24.

    Table 3-24  Upgrade parameters

    Parameter

    Description

    Setting

    Auto upgrade

    Specifies whether the automatic upgrade function is enabled. If you set this parameter to Enable, you must also set Upgrade interval, Server address, User name, and Password. Your endpoint will obtain upgrade files from the specified server and install the files when the specified upgrade interval is reached.

    This parameter is deselected by default.

    Upgrade interval

    Specifies the upgrade interval. This parameter is available only when Auto upgrade is selected.

    The default value is 0.5 h.

    Value range: 0.5 h to 24 h

    Confirm before upgrade

    Specifies whether the automatic upgrade starts only after being confirmed.

    The default value is Enable.

    Server address

    Specifies the IP address or domain name of the server that stores the upgrade files for your endpoint.

    This parameter cannot be left blank.

    User name

    Password

    Specifies the user name and password your endpoint uses to access the server.

    No default value is set for these parameters.

  4. Perform either of the following:

    • If you selected Auto upgrade, click Save.
    • Click Manual Upgrade.

Translation
Download
Updated: 2019-12-02

Document ID: EDOC1100044672

Views: 15004

Downloads: 17

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next